Develop a 4x4 multiplier. using VLSI Magic Irsim

Develop a 4x4 multiplier. The multiplier uses a shift and add algorithm. The multiplier uses 2 phase clocking system
(Using carry ripple adder)

The inputs for the multiplier are A (A3, A2, A1, A0) and B (B3, B2, B1, B0), Reset and Start.

The outputs for the multiplier are O (O7, O6, O5, O4, O3, O2, O1, O0), and Finish

The operation of the multiplier is as follows

1. When Reset = 1 the system is reset

2. When start = 1 the following occurs

a. Load A on the first phi1

b. Load B on the first phii1

c. After n cycles the output is stored in O and the Finish output is asserted

d. There is no change to the output after subsequent cycles.


-In this phase you are implement your project in (Magic.)

Prepare a well organized and well written report that describes your design, and simulation results.

Just to confirm, I want the project to be done on the Magic irsim program, with 2 phase clock and scmos100.prm technology.
I want it on 12/06/2023