Need System admin to Configure HPE Synergy Console
Budget: $25 – $50 USD
I need an admin familiar with configuring and troubleshooting the HP Synergy 12000 chassis. I am running into issues and want someone to configure and setup the chassis for us.
Please watch the attached video.
Our first issue can be seen in this video. We have a chassis we purchased and have installed the Synergy Composer card and the image streamer card. When we connect directly to the chassis we load the Synergy console through VNC. The screen loads properly and shows all of the hardware healthy.
We then click Connect to Oneview. The screen as seen takes 10-15 min to boot and begin loading Oneview, but then it shows a screen that says . The oneView appliance(s) in this frame are not responding. If an install of upgrade is in progress, do not reset the oneview appliance. Otherwise click reset to restart all Oneview appliances in this frame.
Need to see what we are doing wrong and get past this so we can install a few servers.
Please only apply if you manage HP Synergy 12000 chassis and can properly upgrade the Firmware.
I am also installing the following cards that i want to make sure are updated to the latest firmware:
Cards Currently Installed:
1. 804353-B21 HPE Synergy Composers (I have 2 of these)
2. HP 804937-B21 SYNERGY IMAGE STREAMER
Cards we will add after we are able to connect to one view. (Need to check firmware update to latest)
1. 867796-B21 HP Virtual Connect SE 100Gb F32 Module 879438-001
2. HP 785338-001 VC SE 16GB FIBRE CHANNEL MOD - 779227-B21, P08477-B21
Please watch the attached video.
Our first issue can be seen in this video. We have a chassis we purchased and have installed the Synergy Composer card and the image streamer card. When we connect directly to the chassis we load the Synergy console through VNC. The screen loads properly and shows all of the hardware healthy.
We then click Connect to Oneview. The screen as seen takes 10-15 min to boot and begin loading Oneview, but then it shows a screen that says . The oneView appliance(s) in this frame are not responding. If an install of upgrade is in progress, do not reset the oneview appliance. Otherwise click reset to restart all Oneview appliances in this frame.
Need to see what we are doing wrong and get past this so we can install a few servers.
Please only apply if you manage HP Synergy 12000 chassis and can properly upgrade the Firmware.
I am also installing the following cards that i want to make sure are updated to the latest firmware:
Cards Currently Installed:
1. 804353-B21 HPE Synergy Composers (I have 2 of these)
2. HP 804937-B21 SYNERGY IMAGE STREAMER
Cards we will add after we are able to connect to one view. (Need to check firmware update to latest)
1. 867796-B21 HP Virtual Connect SE 100Gb F32 Module 879438-001
2. HP 785338-001 VC SE 16GB FIBRE CHANNEL MOD - 779227-B21, P08477-B21