SOLIDWORKS/FUSION 360 3D MODEL - WATER TANK AND BASE
Budget: $10 – $30 USD
I am looking for a skilled designer who can create a 3D model of a water tank and base using SOLIDWORKS or Fusion 360 software. The project requires the following:
- Water tank capacity: More than 5000 liters (12 mts x 2.7 mts x 2.4 mts)
- Tank material: HR A36 Steel
The tank will have inside two steel sheets in charge of limiting the movement of water. In the upper part, there will be a tube through which the water from the tank is filled, 40 cm high and 12 inches in diameter. On one side it will have an 18-inch tank drain pipe.
- Base Description: The base will be made only of drill pipes bent at their ends to make like a sled for the water tank.
Skills and experience required for this job:
- Proficiency in SOLIDWORKS or Fusion 360 software
- Strong understanding of 3D modeling and design principles
- Experience in designing water tanks and bases
- Attention to detail and ability to meet project specifications
If you have the necessary skills and experience, please submit your proposal, attached you would find the hand sketch.
- Water tank capacity: More than 5000 liters (12 mts x 2.7 mts x 2.4 mts)
- Tank material: HR A36 Steel
The tank will have inside two steel sheets in charge of limiting the movement of water. In the upper part, there will be a tube through which the water from the tank is filled, 40 cm high and 12 inches in diameter. On one side it will have an 18-inch tank drain pipe.
- Base Description: The base will be made only of drill pipes bent at their ends to make like a sled for the water tank.
Skills and experience required for this job:
- Proficiency in SOLIDWORKS or Fusion 360 software
- Strong understanding of 3D modeling and design principles
- Experience in designing water tanks and bases
- Attention to detail and ability to meet project specifications
If you have the necessary skills and experience, please submit your proposal, attached you would find the hand sketch.