Meetingroom Display Designing with Solid Works
Budget: $30 – $250 USD
We are a drawer slide manufacturer and we want to design and build several displays for our Meeting room in the US which basically show the key products for certain industry's. We have existing displays and follow their design to keep it consistent.
We would like to start with a Display for the woodworking industry.
The display will be produced of Plywood.
It has a footprint of 600mm x 600mm and will be 1500mm high.
The upper part of the Display (2/3) will be designed as a pantry pull out drawer/cube with a clean reach in handle.
This cube will be pulled out until full extension with one of our slides.
When fully extended there are going to be 4-6 drawers inside this cube which then will be pulled out to the left or right side.
To avoid tipping over the display needs to have a footer plate on the bottom to extend the base further out so it does not tip when the main drawer get extended.
We can provide Step files for the slides that would need to be implemented and would need this Display designed and forwarded as a STEP, DXF, and DWG file that we can share them with furniture manufacturers.
We see this design as a one off project but we do have more in the pipeline that we want to get created. We also have sometimes special requirements on adapting 3D Data. And for these we look for a external expert we could use as an additional resource.
We would like to start with a Display for the woodworking industry.
The display will be produced of Plywood.
It has a footprint of 600mm x 600mm and will be 1500mm high.
The upper part of the Display (2/3) will be designed as a pantry pull out drawer/cube with a clean reach in handle.
This cube will be pulled out until full extension with one of our slides.
When fully extended there are going to be 4-6 drawers inside this cube which then will be pulled out to the left or right side.
To avoid tipping over the display needs to have a footer plate on the bottom to extend the base further out so it does not tip when the main drawer get extended.
We can provide Step files for the slides that would need to be implemented and would need this Display designed and forwarded as a STEP, DXF, and DWG file that we can share them with furniture manufacturers.
We see this design as a one off project but we do have more in the pipeline that we want to get created. We also have sometimes special requirements on adapting 3D Data. And for these we look for a external expert we could use as an additional resource.