Make 3D drawing for production of plastic box
Budget: $10 – $30 USD
I need a wall mounted waterproof box for some electronics project.
The box have wings for wall mounting
The box wall are around 4 mm thick
The lid goes on the top of the box.
The lidt must be screwed in from the sides of the box
The lid should extend over the box it self, and have a little drip edge, so the water goes down the sides of the box and not in the box.
There is a 1 mm deep track around the top walls (red line in the drawing) where I can put in some sealant before putting the lid on.
The box will be printed on a 3D printer so you must provide 3D files for that.
On the lid of the box, there should be a small solar panel mounted (green on the drawing) . The panel measure 68,5 * 36,5 mm and thickness of 2,3 mm. I need a protective edge around the solar panel of 3 mm hight. So I can put in glue in this space, and then press the solar panel down in it.
The box have wings for wall mounting
The box wall are around 4 mm thick
The lid goes on the top of the box.
The lidt must be screwed in from the sides of the box
The lid should extend over the box it self, and have a little drip edge, so the water goes down the sides of the box and not in the box.
There is a 1 mm deep track around the top walls (red line in the drawing) where I can put in some sealant before putting the lid on.
The box will be printed on a 3D printer so you must provide 3D files for that.
On the lid of the box, there should be a small solar panel mounted (green on the drawing) . The panel measure 68,5 * 36,5 mm and thickness of 2,3 mm. I need a protective edge around the solar panel of 3 mm hight. So I can put in glue in this space, and then press the solar panel down in it.