Universal P10-P8 LED Controller PCB

I need a compact LED-controller PCB designed from scratch that can drive HUB-type P10, P8, and P6/P4 display panels while interfacing cleanly with a Raspberry Pi Zero 2 W (and, by extension, my own Pi-based carrier board). The board should plug straight into the Pi’s 40-pin header, buffer all necessary signals, supply panel power, and expose simple test points so I can verify each channel with a multimeter before first power-up.

What I expect from you
- first show your skills mentioned below test
- Lets talk about what features i need in my own controller
- check feasibility first and do analysis and share possibilities
• knowledge about git to show daily progress
• Proper documentation of complete work
- Neat and clean board design with 3d models
- send me proto where it is running
- it should work on all kinds of led boards

Test:
Before giving project to any one I need candidate to share some demo over lets say how to connect raspberry pi zero 2 w to p10 led board with out using any ready made hats like adafruit. Use logic level shifter to do this. You can give fritzing for this and show me how you do that. This is hardly an 15 min job for an experienced company.

Lets pick P10 pannel 16*32 with a chain of 3

Please do not do any time pass if you don’t had knowledge on this domain.

Acceptance
Once I receive the files, i will review how you design and code.
Rest of the information i will share after this only.
Designed controller must had inbuilt wifi where it can connect it to internet as soon as its nearby available via wifi

Had a capability to send commands online through intert

Can point to my own server or api which can be customized