Raspberry Pi Camera Application
Budget: £10 – £100 GBP
I need a custom Raspberry Pi application to stream TP-Link TAPO IP cameras to the HDMI to display on a normal TV.
The camera stream is RTSP in the URL format of rtsp://username:password@.192.168.0.xxx:554/stream1
The application needs to be able to be configurable with editable username, password, IP addresses and camera names with Add / Remove / Edit camera. All IP addresses are on the same subnet.
There will be 5 cameras at present but this will need to be expandable up to 8 in total.
The main screen on the application should have 3 basic modes:
1. All cameras on screen at once in a 4 x 2 grid format. Clicking one camera shall enter mode 3.
2. Continuous cycle through each camera at a configurable rate. Clicking the current screen will enter mode 3.
3. Display single camera image full screen and remain. Clicking the image shall revert back to the last mode.
The application should automatically load when the Raspberry Pi is powered up. I can provide a camera to work with if needed.
The camera stream is RTSP in the URL format of rtsp://username:password@.192.168.0.xxx:554/stream1
The application needs to be able to be configurable with editable username, password, IP addresses and camera names with Add / Remove / Edit camera. All IP addresses are on the same subnet.
There will be 5 cameras at present but this will need to be expandable up to 8 in total.
The main screen on the application should have 3 basic modes:
1. All cameras on screen at once in a 4 x 2 grid format. Clicking one camera shall enter mode 3.
2. Continuous cycle through each camera at a configurable rate. Clicking the current screen will enter mode 3.
3. Display single camera image full screen and remain. Clicking the image shall revert back to the last mode.
The application should automatically load when the Raspberry Pi is powered up. I can provide a camera to work with if needed.
Related categories:
Raspberry Pi