Python Automation on Raspberry Pi

Looking for an experienced Python/Embedded developer to adapt an existing Raspberry Pi pressure-control project for a Nano-based board.

Current application:
- Reads air pressure from a sensor
- Turns a motor on when pressure falls below threshold
- Runs hourly checks
- Existing code is approximately 75-90% complete

Requirements:
- Refactor and finalize the code for Nano hardware
- Configure GPIO, sensors, motor, and indicators
- Enable automatic startup after boot or power loss
- Create a Windows batch deployment script
- Provide setup documentation and pin mapping
- Verify reliable operation through power-cycle testing

Deliverables:
- Updated Python source code
- Windows deployment script
- README documentation
- Power-cycle test confirmation