EasyEDA PCB 4 Zone Amplifier Design - only open to my previous freelancer in Pakistan - freelancer have messed up - its Graham
Budget: £250 – £750 GBP
I have a consumer-electronics circuit that now needs to move from breadboard to a production-ready printed circuit board. The finished board will be larger than 10 cm on its longest side and must be laid out as a multi-layer design in EasyEDA so that I can keep the workflow inside JLCPCB’s ecosystem.
I will supply the rough schematic, component list, and mechanical outline. Your task is to refine the schematic where necessary, create a clean multi-layer PCB layout that respects signal integrity and manufacturability rules, and deliver the full EasyEDA project with Gerbers, drill files, BOM, and pick-and-place data ready for ordering.
Acceptance criteria
• EasyEDA project opens without errors and matches the supplied outline (>10 cm).
• All nets from the schematic are correctly routed on multiple layers with appropriate clearances.
• DRC passes using JLCPCB’s default rule set.
• Gerber viewer shows correct layer stack, board dimensions, and hole positions.
If you have recent experience designing large consumer-electronics boards in EasyEDA, this should be a straightforward assignment.
I already have the schematic and PCB but I recently lost my original access to my Freelancer
I will supply the rough schematic, component list, and mechanical outline. Your task is to refine the schematic where necessary, create a clean multi-layer PCB layout that respects signal integrity and manufacturability rules, and deliver the full EasyEDA project with Gerbers, drill files, BOM, and pick-and-place data ready for ordering.
Acceptance criteria
• EasyEDA project opens without errors and matches the supplied outline (>10 cm).
• All nets from the schematic are correctly routed on multiple layers with appropriate clearances.
• DRC passes using JLCPCB’s default rule set.
• Gerber viewer shows correct layer stack, board dimensions, and hole positions.
If you have recent experience designing large consumer-electronics boards in EasyEDA, this should be a straightforward assignment.
I already have the schematic and PCB but I recently lost my original access to my Freelancer