Small Electronics enclosure
Budget: $30 – $250 USD
I am seeking a skilled freelancer to design and create a small electronics enclosure for my project. The enclosure should have the following specifications:
Size Requirement:
- The enclosure will be small, with dimensions max 100 x 60 x 10 mm
- See pictures for first design draft
Intended Use:
- The enclosure will be for electronic sensors inside shipped goods. Can get cold and hot but not wet.
- There will be a battery cover to easily change batteries
- The design should include a low cost 4-wire connector that will allow the device to be electrically connected to a docking station. The docking station will be designed later, based on this design.
- It should either be a cut-out for GPS antenna or a thicker enclosure to accommodate it. The antenna is 8 mm thick while rest of the box thickness is limited by battery thickness. A thinner and smaller enclosure is preferred, but designer should advise.
Material Preference:
- The enclosure should be made of plastic.
- The enclosure should protect electronics inside well
Skills and Experience:
- Experience in designing and creating small electronics enclosures for PCBs and batteries.
- Proficiency in working with plastic materials.
- Knowledge of industry standards and best practices for enclosure design.
- Attention to detail
If you have the skills and expertise required for this project, please submit your proposal.
Size Requirement:
- The enclosure will be small, with dimensions max 100 x 60 x 10 mm
- See pictures for first design draft
Intended Use:
- The enclosure will be for electronic sensors inside shipped goods. Can get cold and hot but not wet.
- There will be a battery cover to easily change batteries
- The design should include a low cost 4-wire connector that will allow the device to be electrically connected to a docking station. The docking station will be designed later, based on this design.
- It should either be a cut-out for GPS antenna or a thicker enclosure to accommodate it. The antenna is 8 mm thick while rest of the box thickness is limited by battery thickness. A thinner and smaller enclosure is preferred, but designer should advise.
Material Preference:
- The enclosure should be made of plastic.
- The enclosure should protect electronics inside well
Skills and Experience:
- Experience in designing and creating small electronics enclosures for PCBs and batteries.
- Proficiency in working with plastic materials.
- Knowledge of industry standards and best practices for enclosure design.
- Attention to detail
If you have the skills and expertise required for this project, please submit your proposal.