Very very simple PCB design!
Budget: £10 – £20 GBP
I am looking for someone to create a very very simple PCB design. The PCB is just a breakout board for a USB-C connector. Although we're using USB-C, we only need the USB2.0 data connections so you don't need to worry about impedance matching, impedance of tracks etc.
Here's the datasheet for the connector we want to use.
https://docs.rs-online.com/0336/0900766b816cf9b5.pdf
We only want to connect to the USB2.0 tracks, so referring to this..
https://en.wikipedia.org/wiki/File:USB_Type-C_Receptacle_Pinout.svg
we want to connect pins
GND = A1, A12, B1, B12
VBUS = A4, A9, B4, B9
D+ = A6, B6
D- = A7, B7
So, for each of these holes, there should be a through hole with solder pad.
Other pins on the USB connector should have holes drilled, but no solder pad.
You'll need to create a custom footprint to do this.
The 4 pins should be tracked to a through hole solder pad that I can solder a wire to. The 4 pads should be labelled on the silkscreen.
Here's the datasheet for the connector we want to use.
https://docs.rs-online.com/0336/0900766b816cf9b5.pdf
We only want to connect to the USB2.0 tracks, so referring to this..
https://en.wikipedia.org/wiki/File:USB_Type-C_Receptacle_Pinout.svg
we want to connect pins
GND = A1, A12, B1, B12
VBUS = A4, A9, B4, B9
D+ = A6, B6
D- = A7, B7
So, for each of these holes, there should be a through hole with solder pad.
Other pins on the USB connector should have holes drilled, but no solder pad.
You'll need to create a custom footprint to do this.
The 4 pins should be tracked to a through hole solder pad that I can solder a wire to. The 4 pads should be labelled on the silkscreen.