Short-distance RF Emitter and Receiver PCBs design
Budget: €30 – €250 EUR
I am designing two PCBs (a RF emitter and a RF receiver) and I would like to find someone to give me a hand with it. A summary of specs is presented below:
- The emitter (Tx pcb) it is like a keyfob. It should incorporate an encoder (HT12D or similar) along with an RF emitter IC and a PCB printed antenna. This board will be powered with a coin cell (3V). There will be only 2 inputs coming into the encoder.
- The receiver (Rx pcb) should incorporate a decoder (HT12E or similar) along with a RF receiver IC and a PCB printed antenna. This board will be powered with a single LiPo Battery (3.7V). There will be 4 outputs. This board should also incorporate a LiPo charging management circuit (TP4056 + DW01 + FS8205) and a DC-DC boost IC (MT3608 or similar) since one of the outputs requires 12V.
I´ll provide you with more details in a private chat.
- The emitter (Tx pcb) it is like a keyfob. It should incorporate an encoder (HT12D or similar) along with an RF emitter IC and a PCB printed antenna. This board will be powered with a coin cell (3V). There will be only 2 inputs coming into the encoder.
- The receiver (Rx pcb) should incorporate a decoder (HT12E or similar) along with a RF receiver IC and a PCB printed antenna. This board will be powered with a single LiPo Battery (3.7V). There will be 4 outputs. This board should also incorporate a LiPo charging management circuit (TP4056 + DW01 + FS8205) and a DC-DC boost IC (MT3608 or similar) since one of the outputs requires 12V.
I´ll provide you with more details in a private chat.