Schematic file to PCB conversion
Budget: ₹600 – ₹800 INR
Hello,I am looking for a skilled person to convert my schematic file into a complete PCB. All the schematic(see the attached image) footprint and placement sites are available thus the PCB conversion won't draw too much time.
The AT32 PCB shall have the following features.
Size: within 4.5×4.5CM
Layers: 4 layers ( 2 layers is preferable)
Components size: 0402/Higher
No. of variation: 2
Panalise: Yes
PCB standards: As per JLC
The PCB needs to look like the image that I have attached with this project(important).
W.R.T variation one PCB needs to have the debugging pads SWDIO and the other variant doesn't need that.Thats the difference.
The schematic has been completed and only small changes/corrections may be pending with reference to the datasheet (important). Paneling with other designs is important to ease the manufacturing task.
The freelancer should know about 6 Axis inertial sensor IC,As the board needs to show the side to which the gyro is pointing at. All others are basic like capacitance, filter design Basic are mandatory.
An separate board which uses the RY8320 is also needs to be done to act as an Power Distribution Board. So,the total no.of design is 2(excluding the variation for the AT32 PCB I mentioned above).
The files were designed using EasyEDA Pro.The freelancer can use any software of their wish upon completion they need to send Schematic,PCB,PNP,BOM and Gerber file all together after completing.
The work won't take an hour if properly concentrated.
The AT32 PCB shall have the following features.
Size: within 4.5×4.5CM
Layers: 4 layers ( 2 layers is preferable)
Components size: 0402/Higher
No. of variation: 2
Panalise: Yes
PCB standards: As per JLC
The PCB needs to look like the image that I have attached with this project(important).
W.R.T variation one PCB needs to have the debugging pads SWDIO and the other variant doesn't need that.Thats the difference.
The schematic has been completed and only small changes/corrections may be pending with reference to the datasheet (important). Paneling with other designs is important to ease the manufacturing task.
The freelancer should know about 6 Axis inertial sensor IC,As the board needs to show the side to which the gyro is pointing at. All others are basic like capacitance, filter design Basic are mandatory.
An separate board which uses the RY8320 is also needs to be done to act as an Power Distribution Board. So,the total no.of design is 2(excluding the variation for the AT32 PCB I mentioned above).
The files were designed using EasyEDA Pro.The freelancer can use any software of their wish upon completion they need to send Schematic,PCB,PNP,BOM and Gerber file all together after completing.
The work won't take an hour if properly concentrated.