PCB Design and Build

I'd like create a circuit board similar to the Sparkfun RTK2 (P/N GPS-15136) board with some circuits that I don't need removed. I attached a picture showing an RTK2 board with the pins and connectors that I don't need crossed out in yellow, and the pins and connectors that I do need circled in green. Id like to add the circuits of an HC-05 Bluetooth module to the board. I will supply the board silhouette (See attached .dxf file), you will have to make all of the components fit with-in that silhouette. The location of the power LED is critical and must stay in location shown in the attached picture. The USB-C port should be a vertical female port and should be on the side of the board opposite of the power LED. Location of the USB-C is not critical but its orientation is. The long side of the USB-C port should run parallel to the long side of the board. The location of the usb-c should be approved by me before the design is finished.

Essentially, you will copying the RTK2 Schematic, deleting unused circuits, adding HC-05 circuits and connecting them to the RTK2 circuits (5v Power, Ground, TXD, RXD). Should be fairly straightforward.

Once the board design is finished, I would like to have a prototype board built for testing.

Schematics and Eagle files for the Sparkfun board are available at address below-
https://www.sparkfun.com/products/15136

Information on the HC-05 Bluetooth module-
https://www.electronicwings.com/sensors-modules/bluetooth-module-hc-05-