FAST CHARGER PCB DESIGN AND RESULTS for an EV vehicle_ Student project
Budget: ₹1,500 – ₹12,500 INR
WE STARTED A PROJECT I.E., FAST CHARGER FOR EV, OUR SENIOURS ALREDY DONE A EV MOTER BIKE. SO WE WOULD LIKE TO START FAST CHARGER.,
OUR CHARGER REQUIREMENTS
Specification Unit
Charger type Should be adaptable for both LFP and Li-NMC batteries by varying the software settings and flashing the codes
Battery Combination 19S6P
Battery voltage 60 V
Charging Current requirement 15 Amps (should be adaptable to charge at 10 amps too)
Noise levels (in the charging current) + or – 0.5 amps
Method of charging (CC-CV) CC-CV charging
CC cutoff voltage Can be varied according to the voltage requirements
Max. Cell cutoff voltage Can be varied according to the voltage requirements
Charging status indictor Yes (either through LED or digital)
Cutoff temp ~45 DegC
Thermal protection availability Yes
Colling method Forced air with a fan
Input power supply Should work for 120V 60hz (or) 240V, 50 hz
OUR CHARGER REQUIREMENTS
Specification Unit
Charger type Should be adaptable for both LFP and Li-NMC batteries by varying the software settings and flashing the codes
Battery Combination 19S6P
Battery voltage 60 V
Charging Current requirement 15 Amps (should be adaptable to charge at 10 amps too)
Noise levels (in the charging current) + or – 0.5 amps
Method of charging (CC-CV) CC-CV charging
CC cutoff voltage Can be varied according to the voltage requirements
Max. Cell cutoff voltage Can be varied according to the voltage requirements
Charging status indictor Yes (either through LED or digital)
Cutoff temp ~45 DegC
Thermal protection availability Yes
Colling method Forced air with a fan
Input power supply Should work for 120V 60hz (or) 240V, 50 hz