Expert Level Altium PCB Design Project based around Onsemi reference board
Budget: $30 – $250 USD
I will need this board to be slightly smaller foot print 40mm by 45mm and add DC jack , but most of the original components as per ONSEMI Schematic
https://www.onsemi.com/pub/collateral/tnd6348-d.pdf
QUALITY Placement as per OnSEMI Requirement for component placement add Design Guideline
Fully Finished Altium Project will render Payment
Active BOM
3D Bodies for all Components
Full Libraries for COmponents Placed on board
Clean Schematic Sheets properly named and linked
Clean PCB Layout as per requirements and Guidelines
AS per Images current Dev Board is expected to heat no more than 75C at 20V 5A output, I hope Quality Layout will be better than Onsemi Reference.
Output Files in project folder ready for PCB Prototype with Clean and Double/Quadruple Checked BOM
Etc. Etc.
https://www.onsemi.com/pub/collateral/tnd6348-d.pdf
QUALITY Placement as per OnSEMI Requirement for component placement add Design Guideline
Fully Finished Altium Project will render Payment
Active BOM
3D Bodies for all Components
Full Libraries for COmponents Placed on board
Clean Schematic Sheets properly named and linked
Clean PCB Layout as per requirements and Guidelines
AS per Images current Dev Board is expected to heat no more than 75C at 20V 5A output, I hope Quality Layout will be better than Onsemi Reference.
Output Files in project folder ready for PCB Prototype with Clean and Double/Quadruple Checked BOM
Etc. Etc.