EDA schematic KiCad 6: complete, review, find errors and correct my schematic
Budget: €30 – €250 EUR
EDA schematic KiCad 6: complete, review, find errors and correct my incomplete schematic, transfer and prepare to layout. The project is called ECSS. It is a prototype of a citizen environmental sensor station.
I want to order the production from https://jlcpcb.com/
So the schematic and BOM have to fit to their constrains and component catalog.
Tasks:
1.) Some components are incomplete or not correct, so for each single component, review it, complete or correct Value, Footprint ... etc ... in a way, that the BOM will automaticly fit to the jlcpcb component catalog when uploading for production without errors or need to assign.
2.) assign footprint for components without.
3.) for R, C and similar change to a Footprint preferably not smaller than 0805, preferably from jlcpcb "basic" components. If needed, draw new Footprint and/or Component.
4.) review schematic for errors and correct them.
5.) find and correct all electrical rules check errors.
6.) re-annutate components.
7.) generate BOM to be uploaded for production to jlcpcb without errors/assignments.
8.) transfer schematic/components to PCB layout.
9.) draw pcb border and place fitting holes for screws to fit into case
https://cdn-reichelt.de/documents/datenblatt/C700/5U330801.pdf
10.) give me back the project and BOM files and newly drawn footprints / components.
When these steps are done, than Your job is finished and I will place the components in the PCB drawing and go on with the project. Later in a new freelancer project I will offer to review my placing and the PCB layout to be done.
Best regards, Peter
I want to order the production from https://jlcpcb.com/
So the schematic and BOM have to fit to their constrains and component catalog.
Tasks:
1.) Some components are incomplete or not correct, so for each single component, review it, complete or correct Value, Footprint ... etc ... in a way, that the BOM will automaticly fit to the jlcpcb component catalog when uploading for production without errors or need to assign.
2.) assign footprint for components without.
3.) for R, C and similar change to a Footprint preferably not smaller than 0805, preferably from jlcpcb "basic" components. If needed, draw new Footprint and/or Component.
4.) review schematic for errors and correct them.
5.) find and correct all electrical rules check errors.
6.) re-annutate components.
7.) generate BOM to be uploaded for production to jlcpcb without errors/assignments.
8.) transfer schematic/components to PCB layout.
9.) draw pcb border and place fitting holes for screws to fit into case
https://cdn-reichelt.de/documents/datenblatt/C700/5U330801.pdf
10.) give me back the project and BOM files and newly drawn footprints / components.
When these steps are done, than Your job is finished and I will place the components in the PCB drawing and go on with the project. Later in a new freelancer project I will offer to review my placing and the PCB layout to be done.
Best regards, Peter