Design Circuit Board / PCB
Budget: $10 – $50 AUD
Hi,
I'm wanting a circuit board / pcb created.
Detection input is 48v.
Output voltage is 6v.
Running power supply is 12v.
Needs to have OPTO ISOLATORS so voltages don't 'cross' paths.
1. Detect input/voltage on the 48v line.
2. Turn on 6 v output.
3. 6v output lasts for x number of seconds / dip switch / POT adjuster.
4. Output of 6v is controlled via a basic IC CHIP which should have some very basic programming.
EG flash once, flash twice, flash 3 times. etc etc.
Would need a dip switch to control how many flashes or 'function' of the IC that is being run.
Thanks
T
I'm wanting a circuit board / pcb created.
Detection input is 48v.
Output voltage is 6v.
Running power supply is 12v.
Needs to have OPTO ISOLATORS so voltages don't 'cross' paths.
1. Detect input/voltage on the 48v line.
2. Turn on 6 v output.
3. 6v output lasts for x number of seconds / dip switch / POT adjuster.
4. Output of 6v is controlled via a basic IC CHIP which should have some very basic programming.
EG flash once, flash twice, flash 3 times. etc etc.
Would need a dip switch to control how many flashes or 'function' of the IC that is being run.
Thanks
T