Custom PCB Schematic & Gerber
Budget: $10 – $30 USD
I need a circuit schematic and Gerber design with 3 power inlets and 1 outlet. If electricity flows from only one inlet, the outlet should activate normally. However, if power comes from two or more inlets simultaneously, the circuit should automatically block the excess inputs, allowing only one inlet to supply power to the outlet, preventing overload or conflicts.
In both the figures all inlet will be type C Female and outlet is type C male. Type C connectors will be connected with the PCB through wire. In some prototype a FPC wire will be used and other normal circular wire will be used.
With regard to the dimension I want it minimal as it could be because overall product depends upon it. With regard to height (as shown in picture) height/thickness should not be more then 2mm with all the electronic stuff on it.
All Power input - 12V DC 50w and Output 12V DC 50w (with minimal transfer loss)
I will be using the thinnest and Flexible PCB material
In both the figures all inlet will be type C Female and outlet is type C male. Type C connectors will be connected with the PCB through wire. In some prototype a FPC wire will be used and other normal circular wire will be used.
With regard to the dimension I want it minimal as it could be because overall product depends upon it. With regard to height (as shown in picture) height/thickness should not be more then 2mm with all the electronic stuff on it.
All Power input - 12V DC 50w and Output 12V DC 50w (with minimal transfer loss)
I will be using the thinnest and Flexible PCB material