Changes needed on existing PCB (Altium)
Budget: $30 – $250 USD
I would need some changes on my PCB which was designed with Altium Designer.
The board is based on an ESP32C3 with some gas sensors.
Changes:
- Implement an electrical battery disconnect switch controlled by Alert Pin (MAX17048) and to be reconnected by VBUS Signal. The Max17048 is already fitted.
- Implement 8 LEDS directly on PCB (like Neopixel ring)
- Implement an force resistive sensor directly on PCB.
And some smaller changes like remove soldering pads etc.
An exact document with details will be sent after agreement.
The board is based on an ESP32C3 with some gas sensors.
Changes:
- Implement an electrical battery disconnect switch controlled by Alert Pin (MAX17048) and to be reconnected by VBUS Signal. The Max17048 is already fitted.
- Implement 8 LEDS directly on PCB (like Neopixel ring)
- Implement an force resistive sensor directly on PCB.
And some smaller changes like remove soldering pads etc.
An exact document with details will be sent after agreement.
Related categories:
Electrical Engineering
PCB Layout
Circuit Design
PCB Design and Layout
Altium Designer