3 x Basic very basic LED / LIGHT PCB
Budget: $10 – $35 AUD
See Attached image, all 3 are the same 'outline'. With the DXF provided.
DXF will be provided to person going ahead with.
DO NOT BID and then ask for more.
Drawing should be done in EASYEDA, parts used should be in stock at JLCPCB.
Small PCB.
1. Has a small hole in center, solder mask around outside
2 x solder pads for power input.
2. No Hole, 18V input, White LEDs lower voltage leds running in series (3-6v??).
- with part so power can be hooked up either way and it won't dmg leds/circuit.
- 2 x solder pads for power input (same as above)
3. RGB WS2812B LEDS in center(3 at least), 12v input.
will need a 4 pin JST connector for input/output, +, -, DIN, DOUT.
Thanks
T
DXF will be provided to person going ahead with.
DO NOT BID and then ask for more.
Drawing should be done in EASYEDA, parts used should be in stock at JLCPCB.
Small PCB.
1. Has a small hole in center, solder mask around outside
2 x solder pads for power input.
2. No Hole, 18V input, White LEDs lower voltage leds running in series (3-6v??).
- with part so power can be hooked up either way and it won't dmg leds/circuit.
- 2 x solder pads for power input (same as above)
3. RGB WS2812B LEDS in center(3 at least), 12v input.
will need a 4 pin JST connector for input/output, +, -, DIN, DOUT.
Thanks
T