EdgeRouter VLAN Firewall Setup (Ubiquiti 6p)
Budget: $250 – $750 USD
I need an EdgeRouter 6P expert to tighten security across all of my VLANs. The router is already running and the tagged networks are live, but the firewall rules are still permissive. Your job is to create a clear rule-set that isolates traffic where appropriate and still lets approved services flow smoothly.
VLANs in scope
• IoT cameras
• IoT Smart Home (switches & outlets)
• IoT non-camera sensors
• Management
• Guest users
• Main data / “everything-else” segment
What I expect
1. A revised configuration that can be pasted directly into the EdgeRouter CLI or loaded via the UNMS / UISP interface.
2. A short document (or annotated screenshot set) explaining the rule logic so I can maintain it later.
3. Brief remote walk-through to verify that each VLAN can only reach what it should (e.g., cameras stream to NVR, guests reach the internet but not LAN, management has full access, etc.).
I am comfortable providing current configs over a secure channel and can test changes quickly. If you’ve built similar multi-VLAN environments on Ubiquiti gear before, this should be straightforward work.
VLANs in scope
• IoT cameras
• IoT Smart Home (switches & outlets)
• IoT non-camera sensors
• Management
• Guest users
• Main data / “everything-else” segment
What I expect
1. A revised configuration that can be pasted directly into the EdgeRouter CLI or loaded via the UNMS / UISP interface.
2. A short document (or annotated screenshot set) explaining the rule logic so I can maintain it later.
3. Brief remote walk-through to verify that each VLAN can only reach what it should (e.g., cameras stream to NVR, guests reach the internet but not LAN, management has full access, etc.).
I am comfortable providing current configs over a secure channel and can test changes quickly. If you’ve built similar multi-VLAN environments on Ubiquiti gear before, this should be straightforward work.