Need to fix boot issue of Juniper SRX340 Firewall

Getting some errors with my Juniper SRX340 after a power outage. It showing the following error after starting:
------------------------------------------------------
U-Boot 2013.07-JNPR-3.1 (Build time: May 03 2016 - 23:50:19)

Using DRAM size from environment: 4096 MBytes
checkboard siege
SATA0: not available
SATA1: not available
SATA BIST STATUS = 0x0
SRX_340 board revision major:1, minor:6, serial #: CY2516AF0102
OCTEON CN7130-AAP pass 1.2, Core clock: 1200 MHz, IO clock: 600 MHz, DDR clock: 667 MHz (1334 Mhz DDR)
Base DRAM address used by u-boot: 0x10f000000, size: 0x1000000
DRAM: 4 GiB
Clearing DRAM...... done
SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB
PCIe: Port 0 link active, 1 lanes, speed gen2
PCIe: Link timeout on port 1, probably the slot is empty
PCIe: Port 2 not in PCIe mode, skipping
Net: octrgmii0
octeon_fdt_broadcom_config: Unknown broadcom phy for octrgmii0
Interface 4 has 1 ports (AGL)
Type the command 'usb start' to scan for USB storage devices.

Boot Media: eUSB usb
Found TPM SLB9660 TT 1.2 by Infineon
TPM initialized
Hit any key to stop autoboot: 0
SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB
SF: 1048576 bytes @ 0x200000 Read: OK
## No elf image at address 0x00100000
Octeon srx_340_ram#

------------------------------------------------------

I will give you Anydesk access to fix error. No USB media is connected with the device. Only TFTP is configured for data transfer.