Mikrotik Configuration - 2 Tunnel Load-Balancing (Mangle-Rule?) -- 2
Budget: €30 – €250 EUR
We have 2 sites that we need to connect.
There are 2 internet lines available on one side, both of which are to be utilized asymmetrically. Both have static IP addresses.
On the other side the router is located in the data center and has only 1 connection. Here, too, there are static IPs.
Concrete work:
-> Setting up 2 tunnels over the respective Internet lines
-> Distribution of the traffic to the 2 lines. Individual connections must only be allowed to go over one line at a time. (Mangle? per-Connection-Classifier?)
-> It must be possible to determine the ratio of the distribution to the 2 lines.
-> The same setup of the tunnels on the other side
-> Existing OSPF must work, because this traffic should be load balanced. Possibly a bridge interface in front of it? We are open for ideas here ;)
We tried to build it with Mangle-Rules but it didn't work out that way. If someone has done something like this before and has experience with it, it should probably be easy.
Router location 1 : Mikrotik CCR1016
Router location 2 : Mikrotik CCR1009
There are 2 internet lines available on one side, both of which are to be utilized asymmetrically. Both have static IP addresses.
On the other side the router is located in the data center and has only 1 connection. Here, too, there are static IPs.
Concrete work:
-> Setting up 2 tunnels over the respective Internet lines
-> Distribution of the traffic to the 2 lines. Individual connections must only be allowed to go over one line at a time. (Mangle? per-Connection-Classifier?)
-> It must be possible to determine the ratio of the distribution to the 2 lines.
-> The same setup of the tunnels on the other side
-> Existing OSPF must work, because this traffic should be load balanced. Possibly a bridge interface in front of it? We are open for ideas here ;)
We tried to build it with Mangle-Rules but it didn't work out that way. If someone has done something like this before and has experience with it, it should probably be easy.
Router location 1 : Mikrotik CCR1016
Router location 2 : Mikrotik CCR1009