AnyCam NVR Integration Setup
Budget: $30 – $250 USD
I already have a Windows-based server ready and need AnyCam installed, licensed, and fully configured so it works as a network video recorder for more than ten wired IP cameras. Your job is to:
• Install/upgrade AnyCam on the server and apply any required codecs or drivers.
• Discover each wired camera on the LAN, add it to AnyCam, and map the correct stream profiles.
• Create a recording plan that writes continuous footage to the designated storage volume while retaining archives per camera in separate folders.
• Verify live view, motion-triggered recording, and playback for every camera.
• Hand over a short hand-off document (or quick screen-share) showing where to adjust camera settings and storage limits.
All cameras are already cabled and receive IP addresses via DHCP; you can coordinate with me if any static mapping is needed. Remote access to the server will be provided over a secure VPN session.
I consider the task complete once I can see stable live feeds and recordings for each camera inside AnyCam without dropped frames or disconnects for 24 hours.
• Install/upgrade AnyCam on the server and apply any required codecs or drivers.
• Discover each wired camera on the LAN, add it to AnyCam, and map the correct stream profiles.
• Create a recording plan that writes continuous footage to the designated storage volume while retaining archives per camera in separate folders.
• Verify live view, motion-triggered recording, and playback for every camera.
• Hand over a short hand-off document (or quick screen-share) showing where to adjust camera settings and storage limits.
All cameras are already cabled and receive IP addresses via DHCP; you can coordinate with me if any static mapping is needed. Remote access to the server will be provided over a secure VPN session.
I consider the task complete once I can see stable live feeds and recordings for each camera inside AnyCam without dropped frames or disconnects for 24 hours.