Firmware Development using the ARM32F407VET6
Budget: $250 – $750 USD
Embedded Controller using the ARM32F407VET to create a high frequency Waveform with adjustable duty cycle. Firmware Development Only, hardware has already been done and it is sufficient to cover the full functions of the code.
The IDE to be used is the STM32Cube or similar(Arduino IDE is not acceptable for this project). The Code must be done in C, it is preferred to use a Open Source tool chain or STM32Cube IDE.
The Controller uses:
- A 320x240 Color Graphics LCD
- Digital Rotational Encoder
- USB to RS232 Bridge IC
- 5 Button Keypad
- 2 Outputs for Square wave signal
- 1 Input I/O for Remote START/STOP of waveform
Other details can be shared about the project, please send specific questions so that answers can be provided.
Project timeline 2 months maximum, must be completed before December 31, 2021
Thanks.
The IDE to be used is the STM32Cube or similar(Arduino IDE is not acceptable for this project). The Code must be done in C, it is preferred to use a Open Source tool chain or STM32Cube IDE.
The Controller uses:
- A 320x240 Color Graphics LCD
- Digital Rotational Encoder
- USB to RS232 Bridge IC
- 5 Button Keypad
- 2 Outputs for Square wave signal
- 1 Input I/O for Remote START/STOP of waveform
Other details can be shared about the project, please send specific questions so that answers can be provided.
Project timeline 2 months maximum, must be completed before December 31, 2021
Thanks.