epoxy expert
Budget: $1,500 – $3,000 AUD
Low exotherm (for potting up to 1L volumes)
•Shore D hardness of 70-75
•Cure and post-cure processing of less than 155 C
•Good toughness
•Relatively low mixed viscosity (10k – 30k cPs)
•Low CTE, as close to stainless-steel as possible
•Capable of operating at pH 2-3, if necessary.
Preferred Potting Material Properties
•Capable of withstanding 10-15 bar pressure delta across the potted area.
•Good mechanical wetting for sealing but not chemically react with the hollow fibers.
•i.e. does not react with or degrade the separation material.
•Capable of withstanding 10-15 bar pressure delta across the potted area.
•Shore D hardness of 70-75
•Cure and post-cure processing of less than 155 C
•Good toughness
•Relatively low mixed viscosity (10k – 30k cPs)
•Low CTE, as close to stainless-steel as possible
•Capable of operating at pH 2-3, if necessary.
Preferred Potting Material Properties
•Capable of withstanding 10-15 bar pressure delta across the potted area.
•Good mechanical wetting for sealing but not chemically react with the hollow fibers.
•i.e. does not react with or degrade the separation material.
•Capable of withstanding 10-15 bar pressure delta across the potted area.