Fabrication Drawings for Steel Purlins - Model is Ready

Hi Freelancer,

I have attached a Tekla model in the link below. As shown in the screenshots, the model is ready where the cleats (small angle profiles) are placed on the purlin (Steel box sections). Though when I generate the assembly model of the purlin to see the cleat location in generated drawings, I am unable to see the cleats along with it. I have tried making the cleats as sub-assembly with the purlin and it works (as shown in image 3). I need the fabrication drawings of each total 1464 steel purlins with the cleats as shown in image 3. Note, Its preferred if the assembly number of the purlins are kept the same to facilitate with fabrication.

I am sure you will have a more efficient way to connect the cleats to the purlin or just to show the cleats with respect to the specific purlin in the drawing.

I care about the distance from one end of the purlin to the respective cleats placed on it.

Please refer to the screenshots for more information and kindly find the Tekla model attached in the Wetransfer link below (2021 Tekla Model)

https://we.tl/t-nSvamrt324

Kindly message if you require further information.

Thanks.
MH