Program Arduino to control RC motor (Figure of 8 path)
Budget: £20 – £250 GBP
I have a RC robot car purchased off the shelf. I've fitted sensors to it. I require code to program Arduino and then send code via WIFI to RC motor car. Car motor must be programmed to follow a path of figure of 8. Please see attached documentation.
The screenshot shows what file should be edited with code.
We have the hardware, and we will test the code on our end. We have a limited time, so project is of utmost urgency.
To recap:
(1) Code car to follow path of figure of 8
(2) Test code
(3) Re-iterate if required
(4) Small report, 10 pages max., outlining steps taken.
(Note - The report can be completed afterwards. The most important part is coding the car)
The screenshot shows what file should be edited with code.
We have the hardware, and we will test the code on our end. We have a limited time, so project is of utmost urgency.
To recap:
(1) Code car to follow path of figure of 8
(2) Test code
(3) Re-iterate if required
(4) Small report, 10 pages max., outlining steps taken.
(Note - The report can be completed afterwards. The most important part is coding the car)