Magnetic Ski Holder Engineering and Sourcing - 01/03/2024 06:18 EST
Budget: $15 – $25 USD
I'm on the hunt for an experienced engineer who can help me complete the design of a magnetic ski holder for a car roof. The design of the stand is completed however, I need help to find a specific magnet sheet that is used for such solutions. The solution needs to comply with below requirements:
- Resistance and Safety Compliance: It must comply with EU standards, ensuring its safety and durability during transit including accidents at speeds up to 60 km/h.
- Material: The magnet must be coated to avoid rust and scratches on the car paint.
- Assembly: The magnetic sheet must be suitable for being glued to the plastic stand design.
- Load Capacity: The stand should be able to hold a weight of 10 kilograms.
The design of the stand is attached in the PDF document.
Finally, I also require supplier sourcing for the project, ideally from the market known for quality and affordability.
For this project, the ideal candidate should have expertise in engineering, strong knowledge of EU safety standards, and have proven experience in supplier sourcing. Can't wait to see your innovative solutions!
- Resistance and Safety Compliance: It must comply with EU standards, ensuring its safety and durability during transit including accidents at speeds up to 60 km/h.
- Material: The magnet must be coated to avoid rust and scratches on the car paint.
- Assembly: The magnetic sheet must be suitable for being glued to the plastic stand design.
- Load Capacity: The stand should be able to hold a weight of 10 kilograms.
The design of the stand is attached in the PDF document.
Finally, I also require supplier sourcing for the project, ideally from the market known for quality and affordability.
For this project, the ideal candidate should have expertise in engineering, strong knowledge of EU safety standards, and have proven experience in supplier sourcing. Can't wait to see your innovative solutions!