I need a Labview Programmer
Budget: €30 – €250 EUR
I want to be able to read different measurements simultaniously and save the measured data. Mainly Force, Temperature and Voltage with the NI-9219 Module. I can already measure the the sensors seperatly/individually.
Also i want to be able to control two Solid State Relays with the NI-9375 Module. The following is what my program should be able to do:
First cycle/iteration would be:
1. Set digital Output to 10 mA to put relay on on-state for "x" seconds.
2. After "x" seconds turn relay 1 off.
Second iteration would be:
3. After Relay 1 is off, switch Relay 2 to on-state for "y" seconds.
4. After "y" seconds turn relay 2 off.
This process ist put in a loop and every iteration should be counted.
Also i want to be able to control two Solid State Relays with the NI-9375 Module. The following is what my program should be able to do:
First cycle/iteration would be:
1. Set digital Output to 10 mA to put relay on on-state for "x" seconds.
2. After "x" seconds turn relay 1 off.
Second iteration would be:
3. After Relay 1 is off, switch Relay 2 to on-state for "y" seconds.
4. After "y" seconds turn relay 2 off.
This process ist put in a loop and every iteration should be counted.
Related categories:
LabVIEW