Front piece Shotgun stock
Budget: $10 – $30 USD
I need a Step.file with a design of the front piece for a shotgun stock.
The pictures have some measurments on in - generaldesign can be traced front canvas?
The design does not need to be exact replice, but the general outlay should be the same.
i use Fusion 360, the file delivered must be compatible.
total lengt 22,3cm / 223mm.
inner hole traced trough all is 30mm - the offset is 15mm for the 35mm hole.
The pictures have some measurments on in - generaldesign can be traced front canvas?
The design does not need to be exact replice, but the general outlay should be the same.
i use Fusion 360, the file delivered must be compatible.
total lengt 22,3cm / 223mm.
inner hole traced trough all is 30mm - the offset is 15mm for the 35mm hole.