CCNP R&S Config, Troubleshoot, Optimize -- 2

I have three network assignments lined up and I want a CCNP-level specialist in Routing and Switching to take full ownership of them. All work is on Cisco gear—primarily ISR and Catalyst routers and switches—plus the firewalls that sit at the edge.

Scope of work
1. Configuration – roll out a fresh router/switch stack, establish VLANs, trunks, and dynamic routing (EIGRP and OSPF) so the new gear drops into production cleanly.
2. Troubleshooting – track down an intermittent routing-loop issue that crops up when BGP fails over, and clear up a STP inconsistency on the access layer switches.
3. Optimization – tighten latency by adjusting path selection, pruning unused VLAN traffic, and tweaking QoS policies affecting the firewalls.

Deliverables
• Updated running-config and startup-config files for every touched device
• A concise change log noting commands run and reasons
• A brief post-task report confirming resolution of the loop issue and summarizing performance gains

I’ll provide console or SSH access as needed and can run remote hands for cable moves. If you’re confident working on live routers, switches, and the interacting firewalls without downtime, let’s get started.