RFEM 6 Model
Budget: $8 – $15 AUD
Only Bid if you can do it in RFEM 6...!
I need a clean, well-organised RFEM 6 model that is ready for analysis. I will provide the general geometry, member sizes, and any drawings you tell me you require. Your job is to translate that information into a fully defined RFEM 6 file, assign the appropriate materials and cross-sections, establish load cases and combinations, and leave the model prepared for me to run and review the analysis results.
Key points
• Model must be built natively in RFEM 6, making full use of its member, surface or solid features as appropriate to the structure.
• All typical load categories—dead, live, wind, etc.—should be created, even if I refine magnitudes later. I mainly need the framework in place.
• Naming conventions and layers should stay tidy so I can follow your logic quickly.
• Deliverable: the .rf6 model file plus a brief text note (PDF or DOCX) describing any assumptions, load combinations generated, and special settings you used.
If you have recent RFEM 6 experience and can turn this around promptly, I am ready to share the drawings and start right away.
I need a clean, well-organised RFEM 6 model that is ready for analysis. I will provide the general geometry, member sizes, and any drawings you tell me you require. Your job is to translate that information into a fully defined RFEM 6 file, assign the appropriate materials and cross-sections, establish load cases and combinations, and leave the model prepared for me to run and review the analysis results.
Key points
• Model must be built natively in RFEM 6, making full use of its member, surface or solid features as appropriate to the structure.
• All typical load categories—dead, live, wind, etc.—should be created, even if I refine magnitudes later. I mainly need the framework in place.
• Naming conventions and layers should stay tidy so I can follow your logic quickly.
• Deliverable: the .rf6 model file plus a brief text note (PDF or DOCX) describing any assumptions, load combinations generated, and special settings you used.
If you have recent RFEM 6 experience and can turn this around promptly, I am ready to share the drawings and start right away.