ETAP Fault Current Simulation Help.
Budget: $10 – $30 CAD
I need an engineer who knows ETAP inside-out to build and run a full fault-current model of my power system. The single-line diagram is ready; what’s missing is a cleanly-configured ETAP file that captures all protective devices, conductor data, and transformer parameters so I can see worst-case fault duties before equipment is ordered.
The task centres on:
• Setting up (or sanity-checking) the short-circuit module, clearing any data inconsistencies, and choosing the correct ANSI / IEC calculation options.
• Delivering a concise PDF and the native .etap file that lets me trace each bus, breaker, and transformer contribution.
I’ll provide the drawings, manufacturer sheets, and any utility data you need. Please highlight any data gaps early, walk me through the model once it balances, and note assumptions inside the report. Accuracy matters more than speed, but I’m ready to move quickly if you are.
The task centres on:
• Setting up (or sanity-checking) the short-circuit module, clearing any data inconsistencies, and choosing the correct ANSI / IEC calculation options.
• Delivering a concise PDF and the native .etap file that lets me trace each bus, breaker, and transformer contribution.
I’ll provide the drawings, manufacturer sheets, and any utility data you need. Please highlight any data gaps early, walk me through the model once it balances, and note assumptions inside the report. Accuracy matters more than speed, but I’m ready to move quickly if you are.