SLM for Mikroe477 click board

Hi

if you can create a slm.hex that works on SLM 3.0.0 the 9160 dev kit so that I can download over SWD to the Mikroe477 click board, then we can talk.
I could not get the Serial LTE modem package to work properly with the trace enabled on the DK. Don't know how you can test without a kit. We have many successful builds but the config files are not correct . What can you do to make this happen. I have a DK connected by USB and nothing else. Hope you can build a standard hex file supporting Cellular Monitor and Serial Terminal. It should run a precompiled version without any reconfig but I can't find one.

============================================================================

Tasks for your effor

1: config the 9160 DK with the newer version of SLM (3.0).

2: Verify that the Cellular Monitor and Serial Terminal work on the DK

3: Using AT commands and our certs, connect to AWS with Manual AT commands on the 9160 DK kit.

4: Later the SWD interface of the Dev Kit will be used to Flash external 9160s with the new modem firmware. Some config files may need to be changed since the 4477 has only one UART port, The SWD is only used to flash the 9160.

5: Run the flashed 4477 in our product and use AT commands to connect to AWS using a serial terminal connected to UART pins of 4477.

6: test app program which runs a batch file of commands to the 9160 on our product to get AWS access.

============================================================================
Project Status: we are at step 3 above.Already we finished 3steps.
We need this completed now.

You have to wrap up step 4, 5, 6


==============================================================================
https://www.mikroe.com/lte-iot-4-click