KiCad STM32 Ethernet Switch Board

I am looking for a freelancer to design both the schematic and PCB layout in KiCad for an embedded hardware project.

Project overview

The board will include:
-> STM32 microcontroller (H7 series preferred, but open to suggestions)
-> Ethernet switch with 3 or more ports
---> One port connected to the STM32 using RMII
---> Two other ports connected to SFP sockets
-> The Ethernet switch can be Microchip KSZ8873 or a similar compatible device
-> No high-speed requirement:
---> 10 Mbps is sufficient
---> 100 Mbps is more than enough

Firmware requirements

-> Firmware does not need to be complex
-> It is sufficient to:
--> Enable the Ethernet controller using STM32CubeMX
--> Load a basic example so the board responds to PING
-> No application-level features are required

Scope of work
-> Complete schematic design
-> Complete PCB layout (including Ethernet, SFP, power, clocks, etc.)
-> Design must be done in KiCad
-> Proper Ethernet and SFP layout practices are required