Handheld Gadget PCB Design
Budget: €8 – €30 EUR
I’m putting together a small consumer-grade handheld gadget and need a straightforward, solder-ready PCB designed around three core features: battery management, 7 segment control, and a single contact button interface.
Scope is intentionally lean—I’m looking for an initial concept that I can move to a quick prototype run without multiple revision cycles. The board have to be with soldered components and it can be single- or double-layer as long as it stays compact .
Deliverables I need:
• Clear schematic showing battery charging with usb c/protection, dupont 4 pin , and button debounce, power button with led intergrate
• PCB layout with Gerber files and drill data, optimized for low-cost fabrication
• Brief assembly notes so I can reproduce your results on the bench
if it is possible to upgrade the shematics i already done and put cheap soldered components on the board like the battery charge in to put the esp 32 , a 2-pin screw terminal block tu put the cable for the contact sencor and pin for the power button
Scope is intentionally lean—I’m looking for an initial concept that I can move to a quick prototype run without multiple revision cycles. The board have to be with soldered components and it can be single- or double-layer as long as it stays compact .
Deliverables I need:
• Clear schematic showing battery charging with usb c/protection, dupont 4 pin , and button debounce, power button with led intergrate
• PCB layout with Gerber files and drill data, optimized for low-cost fabrication
• Brief assembly notes so I can reproduce your results on the bench
if it is possible to upgrade the shematics i already done and put cheap soldered components on the board like the battery charge in to put the esp 32 , a 2-pin screw terminal block tu put the cable for the contact sencor and pin for the power button
Related categories:
Electronics
Electrical Engineering
PCB Layout
Circuit Design
Soldering
Embedded Systems