Custom Hardware Integration Setup
Budget: ₹600 – ₹1,500 INR
I’m looking for an experienced engineer who can take my custom-built hardware and make it work seamlessly within a larger system. The heart of the job is hands-on hardware integration—not general project management—so I need someone who is comfortable troubleshooting boards, refining firmware, and confirming that every physical connection and signal behaves as intended.
Key goals
• Map out the integration plan for the custom boards, interfaces, and peripherals I already have on hand.
• Develop or refine any required low-level firmware so the hardware communicates reliably with the host system.
• Validate the full signal chain with bench testing, basic stress tests, and a succinct report of results.
What I’ll provide
– Schematics, component datasheets, and existing PCB layouts.
– A list of functional requirements and test cases.
– Remote access to a lab PC (or shipped units if needed for on-site work).
What I’d like to receive
• A clearly documented wiring diagram and updated schematics reflecting any changes.
• Compiled and source firmware files, with comments explaining key routines.
• A short test report summarizing procedures, outcomes, and any follow-up recommendations.
Familiarity with common toolchains such as KiCad/Altium, STM32CubeIDE (or comparable MCU IDEs), and standard lab equipment (oscilloscope, logic analyzer) will help you move quickly. If you have a proven track record integrating custom hardware or IoT prototypes, I’d love to see a brief example in your proposal.
Key goals
• Map out the integration plan for the custom boards, interfaces, and peripherals I already have on hand.
• Develop or refine any required low-level firmware so the hardware communicates reliably with the host system.
• Validate the full signal chain with bench testing, basic stress tests, and a succinct report of results.
What I’ll provide
– Schematics, component datasheets, and existing PCB layouts.
– A list of functional requirements and test cases.
– Remote access to a lab PC (or shipped units if needed for on-site work).
What I’d like to receive
• A clearly documented wiring diagram and updated schematics reflecting any changes.
• Compiled and source firmware files, with comments explaining key routines.
• A short test report summarizing procedures, outcomes, and any follow-up recommendations.
Familiarity with common toolchains such as KiCad/Altium, STM32CubeIDE (or comparable MCU IDEs), and standard lab equipment (oscilloscope, logic analyzer) will help you move quickly. If you have a proven track record integrating custom hardware or IoT prototypes, I’d love to see a brief example in your proposal.