Capacitive Touch Lamp PCB
Budget: ₹600 – ₹1,500 INR
I need a complete PCB design that turns a single capacitive-touch pad into a sleek three-mode LED lamp. A single tap should cycle the LEDs through warm, warm white, and white; no extra buttons or mechanical switches.
Power & charging
• Runs from a single-cell Li-ion chemistry (LiPo or LiFePO4).
• Charges over a USB-C input.
• On-board BMS must provide both over-charge and over-discharge protection.
What I expect from you
• Schematic, PCB layout, and production-ready Gerbers.
• An annotated BOM with readily available components.
• Native design files (KiCad, Altium, or Eagle—your choice) so I can iterate later.
• A short design note explaining the touch interface IC, LED driver choice, and the way the BMS is wired in.
I’ll validate the work by flashing prototypes and confirming stable charging, touch responsiveness, and proper colour-temperature switching. If the above sounds clear, let’s build a lamp that feels as good as it looks.
Power & charging
• Runs from a single-cell Li-ion chemistry (LiPo or LiFePO4).
• Charges over a USB-C input.
• On-board BMS must provide both over-charge and over-discharge protection.
What I expect from you
• Schematic, PCB layout, and production-ready Gerbers.
• An annotated BOM with readily available components.
• Native design files (KiCad, Altium, or Eagle—your choice) so I can iterate later.
• A short design note explaining the touch interface IC, LED driver choice, and the way the BMS is wired in.
I’ll validate the work by flashing prototypes and confirming stable charging, touch responsiveness, and proper colour-temperature switching. If the above sounds clear, let’s build a lamp that feels as good as it looks.
Related categories:
Electronics
Electrical Engineering
PCB Layout
Circuit Design
Embedded Systems
Prototyping
Product Development