Stepper / Servo Motor Control with RS485 protocol (Industrial Project)
Budget: €200 – €1,000 EUR
PLEASE NOTE: We are not looking for hobby project and are looking for hand on experience in controlling the Servo / Stepper motors.
We are developing a project and needs to control Nema 34 Stepper and Servo motors with drivers. Servo will have 10Nm Torque & Stepper will be 8Nm Torque.
We would prefer the candidate who has test hardwares (Including Motors & Drivers) with them.
Touchscreen control panel with RS485 communication protocol will be used.
1) Switch On / OFF individual motors
2) Set separate speed for each motors
3) Control the direction of each motors
4) Set the number of rotation for each motors
5) Will have a drop down button against each motor with a number from 0 to 8
For testing pupose we will selct the number, this number will be for assigning the motor the positon of starting. A motor assigned number 3 will start after motors assigned 2 finishes the process.
All the stepper and servo drivers will be communicating through RS485.
This will be PHASE 1 of the project, we have divided the project in 4 phases.
We are developing a project and needs to control Nema 34 Stepper and Servo motors with drivers. Servo will have 10Nm Torque & Stepper will be 8Nm Torque.
We would prefer the candidate who has test hardwares (Including Motors & Drivers) with them.
Touchscreen control panel with RS485 communication protocol will be used.
1) Switch On / OFF individual motors
2) Set separate speed for each motors
3) Control the direction of each motors
4) Set the number of rotation for each motors
5) Will have a drop down button against each motor with a number from 0 to 8
For testing pupose we will selct the number, this number will be for assigning the motor the positon of starting. A motor assigned number 3 will start after motors assigned 2 finishes the process.
All the stepper and servo drivers will be communicating through RS485.
This will be PHASE 1 of the project, we have divided the project in 4 phases.