Stepper Motor / Servo Motor controlled with RS485 Modbus Protocol -- 2
Budget: $200 – $1,000 AUD
We are developing a project and needs to control Nema 34 Stepper (24v DC to 48V DC) and Servo motors (230 V AC) with drivers. Servo will have 10Nm Torque & Stepper will be 2Nm to 8Nm Torque.
Project will have 7 stepper & 1 servo motor. All communication will be through RS485.
Touchscreen control panel with RS485 communication protocol will be used.
Project Requirement:
1) Switch ON / PAUSE / RESTART
Switching on START the system.
Screen will show the option to start each motor.
1) Start time: In seconds / condition*
2) Start Direction: Option to Select DO NOT ROTATE / LEFT / RIGHT
3) End Time: In seconds / condition*
4) End Direction: Option to Select DO NOT ROTATE / LEFT / RIGHT
5) Motor Speed: Option to select from 0 to 100
Motor full cycle - All motors will start based on the selected "start position", "set speed", "first direction" + "number of rotations", "second direction" + "number of rotations" or based on "Conditions".
*Conditions - There will be sensors in the project, the output from the sensors would provide next step for the motors.
This will be PHASE 1 of the project, we have divided the project in 4 phases. We are looking to work with a good freelancer to complete all phases.
Project will have 7 stepper & 1 servo motor. All communication will be through RS485.
Touchscreen control panel with RS485 communication protocol will be used.
Project Requirement:
1) Switch ON / PAUSE / RESTART
Switching on START the system.
Screen will show the option to start each motor.
1) Start time: In seconds / condition*
2) Start Direction: Option to Select DO NOT ROTATE / LEFT / RIGHT
3) End Time: In seconds / condition*
4) End Direction: Option to Select DO NOT ROTATE / LEFT / RIGHT
5) Motor Speed: Option to select from 0 to 100
Motor full cycle - All motors will start based on the selected "start position", "set speed", "first direction" + "number of rotations", "second direction" + "number of rotations" or based on "Conditions".
*Conditions - There will be sensors in the project, the output from the sensors would provide next step for the motors.
This will be PHASE 1 of the project, we have divided the project in 4 phases. We are looking to work with a good freelancer to complete all phases.