Single-Layer Op-Amp PCB
Budget: $10 – $30 USD
I’m putting together a small hobby circuit centered on about 16 operational amplifier based aidiotic filters and need a clean, single-layer PCB layout to bring it to life. The schematic is already available from TI for OPA1602.
Here’s what I expect:
• A single-sided layout, large ground planes, keeps traces short and avoids jumpers where possible.
• Project files in KiCad - Schematic and PCB only.
Nothing else is needed.
Acceptance check: the files should load without DRC errors in the native tool, and a quick 3D view must confirm there are no component overlaps. Once these points are met, I’ll mark the project complete immediately.
Here’s what I expect:
• A single-sided layout, large ground planes, keeps traces short and avoids jumpers where possible.
• Project files in KiCad - Schematic and PCB only.
Nothing else is needed.
Acceptance check: the files should load without DRC errors in the native tool, and a quick 3D view must confirm there are no component overlaps. Once these points are met, I’ll mark the project complete immediately.