SimHub Arduino setup support MUST KNOW SIMHUB
Budget: £20 – £250 GBP
I am looking for someone experienced with SimHub and Arduino (Mega 2560 / Leonardo) to help me get my motion rig fully connected again.
The system was working fine before, but after I unplugged and re-routed all the USB cables to tidy up, SimHub now only connects to part of the setup. I have already reinstalled the drivers, and Device Manager shows the boards, but SimHub won’t recognise all of them correctly. It seems to be a COM port conflict or firmware issue.
⸻
What I Need:
• Remote support (via Teams, AnyDesk, or TeamViewer) to:
1. Check my Arduino drivers (Mega 2560 / Leonardo).
2. Clean up / reassign COM ports if needed.
3. Upload the correct SimHub sketches to each board.
4. Ensure both Arduinos show as Connected in SimHub.
5. Map motors 1–8 properly across the boards.
⸻
Requirements:
• Experience with SimHub Arduino setup (multiple boards).
• Comfortable with Windows Device Manager, COM port management, and Arduino IDE if needed.
• Able to guide me or remote in securely to resolve this.
⸻
Notes:
• The rig is already wired and was running fine until the USB ports were changed.
• Drivers are installed, but only one board shows as connected in SimHub.
• Urgent support needed so I can get the rig back online.
The system was working fine before, but after I unplugged and re-routed all the USB cables to tidy up, SimHub now only connects to part of the setup. I have already reinstalled the drivers, and Device Manager shows the boards, but SimHub won’t recognise all of them correctly. It seems to be a COM port conflict or firmware issue.
⸻
What I Need:
• Remote support (via Teams, AnyDesk, or TeamViewer) to:
1. Check my Arduino drivers (Mega 2560 / Leonardo).
2. Clean up / reassign COM ports if needed.
3. Upload the correct SimHub sketches to each board.
4. Ensure both Arduinos show as Connected in SimHub.
5. Map motors 1–8 properly across the boards.
⸻
Requirements:
• Experience with SimHub Arduino setup (multiple boards).
• Comfortable with Windows Device Manager, COM port management, and Arduino IDE if needed.
• Able to guide me or remote in securely to resolve this.
⸻
Notes:
• The rig is already wired and was running fine until the USB ports were changed.
• Drivers are installed, but only one board shows as connected in SimHub.
• Urgent support needed so I can get the rig back online.