Signal Processing Circuit Board Design
Budget: $30 – $250 USD
I'm in need of a skilled circuit board designer that can create the and design the Greber file for me, I need to send the files to the manufacturing compony.
My project contains few components only. SAM D11C 14-pin chip, 3 LEDS, Battery holder, and a reset switch. The "j2" pads are for programming the chip, Gnd, power, and clock. The 2 antennas traces are connected to analog pins A2 and A4. LEDs are connected to digital pins 24,25,31. the reset button to RST pin of course.
For the 4 programming pads. Gnd and Power goes to Gnd and VDD pins in the chip, For the clock, I'm not shire which pins.
layout size : 10 cm by 5.398 cm
My project contains few components only. SAM D11C 14-pin chip, 3 LEDS, Battery holder, and a reset switch. The "j2" pads are for programming the chip, Gnd, power, and clock. The 2 antennas traces are connected to analog pins A2 and A4. LEDs are connected to digital pins 24,25,31. the reset button to RST pin of course.
For the 4 programming pads. Gnd and Power goes to Gnd and VDD pins in the chip, For the clock, I'm not shire which pins.
layout size : 10 cm by 5.398 cm