Read infrared signal with ESP32-C3-WROOM-02
Budget: €250 – €750 EUR
An individual infrared signal should be read by ESP32 and the code should be sent as UDP message via WIFI.
Based on the infrared signal three PWM signals shall control an RGB LED, which has to change color on receive of IR-Signal.
Requirements:
Code written in VS-Code.
Code should run on ESP32-C3-DevKitC-02.
Modification of all network settings (IP-address of ESP32, destination IP-address and ports) via special network commands.
Startup color of LED and changed color defineable.
If we come to an agreement, I will provide an exact documentation of the IR-signal (it is close to Manchester code with a frequenzy of 1kHz and 2kHz) and the information about the configuration commands.
Based on the infrared signal three PWM signals shall control an RGB LED, which has to change color on receive of IR-Signal.
Requirements:
Code written in VS-Code.
Code should run on ESP32-C3-DevKitC-02.
Modification of all network settings (IP-address of ESP32, destination IP-address and ports) via special network commands.
Startup color of LED and changed color defineable.
If we come to an agreement, I will provide an exact documentation of the IR-signal (it is close to Manchester code with a frequenzy of 1kHz and 2kHz) and the information about the configuration commands.
Related categories:
C Programming
Electronics
Microcontroller
Electrical Engineering
C++ Programming