Raspberry Pi Custom Carrier Board
Budget: $10 – $50 USD
I am looking for someone to design a custom raspberry pi carrier board. The carrier board will have the following:
1. For use with the Raspberry Pi Compute Module 3+
2. Solid state relay for control
3. 5v Barrel Jack connected for power
4. Wi-Fi Module
5. Ethernet RJ45 Connection
6. HDMI Connection
7. 1xUSB 3.0 Connection
8. Standard 40 pin GPIO Header
The form factor of the board is important. Details Below:
1. Ethernet RJ45, Barrel Jack Connector and Solid State Relay must all be on the same edge of the board
2. HDMI and USB connection on the opposite edge of the board
3. The form factor / aspect ratio is long and narrow (similar in ratio to a phone)
1. For use with the Raspberry Pi Compute Module 3+
2. Solid state relay for control
3. 5v Barrel Jack connected for power
4. Wi-Fi Module
5. Ethernet RJ45 Connection
6. HDMI Connection
7. 1xUSB 3.0 Connection
8. Standard 40 pin GPIO Header
The form factor of the board is important. Details Below:
1. Ethernet RJ45, Barrel Jack Connector and Solid State Relay must all be on the same edge of the board
2. HDMI and USB connection on the opposite edge of the board
3. The form factor / aspect ratio is long and narrow (similar in ratio to a phone)