Portable Tracker Development (Hardware and Firmware) 2G, GPS and RF. All schematic and circuit board at Eagle.

I need all editable files and also in production format (gerber). I also need the list of components (BOM), with code from some supplier (example mouser or digikey or other).
I need all component libraries used in eagle

For the firmware I need all used libraries, source code and compiled.



use the following components
STM32F030CCT6
G510-GL LCC (GSM, GPS)
RF69(RF Module)

Lithium battery 2500ma
You should use flash memory to store up to 1000 positions, when I have no gprs signal (download in fifo mode).

Tracker must have USB connector to: configure equipment and charge the battery, panic button and accelerometer.


Firmware must have following requirements

Transmit and receive TCP socket
Update firmware via FOTA
Activate RF module only when there is no GPRS signal
Receive configuration commands via socket, usb, sms
Sleep module (disables gps and gsm modules until transmission) ;


Data required for submission on the platform
equipment series
Latitude
Longitude
Speed
direction
GPS Date (GMT)
number of satellites
internal battery voltage
inform if the module is in fashion loading
battery percentage


Generate alert in the cases below.
low internal battery
jammer
Panic





Required settings
On-the-go communication time in seconds
communication time stopped
server ip
Server port
Time to sleep in seconds (where 0 does not use active sleep)
configure equipment series with 9 digits






Payment in 3 steps:
1) After completing the electronic scheme (25 %)
2) After completing PCB(25%)
3) After completing Firmware (50%)