PCB with Motion Sensor to operate 12VDC/1W fan, dual power supply (12VDC & 220VAC) and RD buzzer
Budget: $30 – $250 USD
Thank you
We requirement a design to include gerber and BOM files.
Our requirement for pcb is as follows
- 45x45x1.5mm max
- PIR motion sensor, 2m sensing range, center location on pcb
- 15min delay relay, 5 minute increment set with jumper
- 12VDC, 3 wire (+ - RD), constant current output, JST XH female
- 12VDC input, JST PH female
- 220VAC-12VDC rectifier, 2Pin/2.5mm pitch terminal connector
- RD Buzzer (intermittent beep on detect fan failure)
PCB similar to the attached picture but with features as specified in our requirement above
We requirement a design to include gerber and BOM files.
Our requirement for pcb is as follows
- 45x45x1.5mm max
- PIR motion sensor, 2m sensing range, center location on pcb
- 15min delay relay, 5 minute increment set with jumper
- 12VDC, 3 wire (+ - RD), constant current output, JST XH female
- 12VDC input, JST PH female
- 220VAC-12VDC rectifier, 2Pin/2.5mm pitch terminal connector
- RD Buzzer (intermittent beep on detect fan failure)
PCB similar to the attached picture but with features as specified in our requirement above