MSP432 Code correction
Budget: $30 – $250 USD
Hello,
I'm trying to integrate a digital analog front end (ADS1292R) with the MSP432P401 development board, but I'm having some problems with receiving the data, because through the interrupts I check what is sent by the slave board. In analyzing the data, I verify that it responds to a command that identifies the read register. But right away I send a command to perform the slave chip identification and it only gives me 0's. I'm suspicious that I made a bad integration of SPI communication. As this is a prototype and I needed a quick analysis of this problem I resorted to development with driverlib, which is not my strong point. Then I need someone with more knowledge to give me some tips on what could be wrong.
Important note :If you respond to this project, please note that it is only intended for users of the TI MSP432P401R development board, if you do not have this integrated do not respond, we will avoid wasting time.
I'm trying to integrate a digital analog front end (ADS1292R) with the MSP432P401 development board, but I'm having some problems with receiving the data, because through the interrupts I check what is sent by the slave board. In analyzing the data, I verify that it responds to a command that identifies the read register. But right away I send a command to perform the slave chip identification and it only gives me 0's. I'm suspicious that I made a bad integration of SPI communication. As this is a prototype and I needed a quick analysis of this problem I resorted to development with driverlib, which is not my strong point. Then I need someone with more knowledge to give me some tips on what could be wrong.
Important note :If you respond to this project, please note that it is only intended for users of the TI MSP432P401R development board, if you do not have this integrated do not respond, we will avoid wasting time.